Frame Assembly
Instructions
Opening Packaging
Each Frame is individually packaged together.
It should consist of:
2 x Uprights (With Feet & Casters Pre – Attached)
2 x Cross Pieces (With Connectors Pre – Installed)
4 x Slot Nuts.
2 x End Caps
4 x Rubber Seal
Position Frame
Lay the frame down in the in the position in will be assembled.
Insert Slot Nuts
Insert a slot nut into
the end of each upright
with the hole nearest
to the end of the frame.
Rotate the upright
so the slot nut is now
facing inside the frame
and the feet are now
perpendicular to the
cross pieces.
Using the Allen Driver
push the connector
through the barrel and
into the slot nut.
Keep the cross peice and
the top of the upright
flush.
Tighten Fully.
Repeat on the opposite
upright.
This will create a ‘U’ shape frame.
This will create a ‘U’ shape frame.
Lift the uprights upward
so the top of the frame is
now on the ground.
This will require 2 people.
This will require 2 people.
Slide the panel into the
inside groove of the frame
The uprights can be pulled
apart to provide enough
space for the panel to be
inserted.
Take Note:
The frame is currently upside down, so the panel will need to be inserted upside down.
Take Note:
The frame is currently upside down, so the panel will need to be inserted upside down.
Take the remaining
cross peice and place it
so the panel goes into the
groove and the connectors
are in the top groove.
Slide the slot nut to align
with the connector and
tighten fully.
Repeat on the opposite side.
Rotate the frame so it is
the correct way up and
freestanding
This will require 2 people.
To prevent the board
from rattling inside of the
frame, add the rubber
seal to the rear of the
panel on all 4 edges.
Add the end caps to the
top of the uprights.
A hammer may be
required.
